Electric Actuators. Electric Actuators TOP. Series LE. e-Actuator Easy to Operate Integrated Controller. Battery-less Absolute Encoder Type. Rod Type. Slider Type. High Rigidity Slider Type. Low Profile Slider Type. Beli Pressure Switch Saginomiya terbaik harga murah Desember 2023 terbaru di Tokopedia! ∙ Promo Pengguna Baru ∙ Kurir Instan ∙ Bebas Ongkir ∙ Cicilan 0%.
SMC'S series AW-B is a combination filter/regulator, minimizing space and piping by integrating two units into one. The AW-B series has a maximum set pressure of 125 psi and offers embedded gauge and pressure switch options not found in the AW-A while maintaining panel mounting interchangeability with the previous AW models.
· Remodeled with a new body for more flexibility. Small auto switches can be mounted on the 4 surfaces. · Auto switches can be mounted at any position on the 4 surfaces to best match the installation conditions. (ø12 to ø25: 2 surfaces) · Improved design flexibility. · The auto switch rail has been removed. Features. ・Applicable fluid: Air, N2. ・Flow range: Max. 12000 L/min. ・Flow ratio 100:1. A wide range of flow measurement is possible with 1 product. ・Improved drainage and resistance to foreign matter. ・Pressure loss: 75% reduction (20 kPa → 5 kPa) ・Through bore construction. ・IO-Link compatible. Set pressure range : ISE30A (positive pressure) Piping : R 1/8 (With M5 female thread) Output : NPN open collector 1 output. Unit : Fixed. Accesories : With connector attached lead wire 2 m. Rated pressure range : -0.100 to 1000 MPa. Set pressure range : -0.105 to 1.050 MPa. Withstand pressure : 1.5 MPa.

[P_2] or [n_2] is displayed. Set OUT2 same as OUT1. The Pressure switch turns on within a set pressure range (from P1L to P1H) during window comparator mode. Set P1L (switch lower limit) and P1H (switch upper limit) with the setting procedure above. When reversed output is selected, [n1L] and [n1H] are displayed.

sufficient pressure required to activate the pressure switch (normally open) in a predetermined period of time (called monitor time) once the pump starts. The user can adjust the monitor time to a setting greater than the time required to satisfy the pressure switch (normally 1.5 times greater). If V9sXrbF.
  • 33ssqeec69.pages.dev/476
  • 33ssqeec69.pages.dev/392
  • 33ssqeec69.pages.dev/475
  • 33ssqeec69.pages.dev/29
  • 33ssqeec69.pages.dev/144
  • 33ssqeec69.pages.dev/48
  • 33ssqeec69.pages.dev/183
  • 33ssqeec69.pages.dev/223

    • cara setting pressure switch smc